Skip to the stories
Mechanical & Manufacturing

University of Queensland Team Sends a Message Through a Brick Wall Using Gravity

  • Mrigakshi Dixit
  • 837 reads

A moving 1.8-tonne elevator counterweight encoded a seven-letter message, which a gravimeter detected through a brick wall at one bit per minute.

University of Queensland Team Sends a Message Through a Brick Wall Using Gravity

A 1.8-tonne elevator counterweight carried a message through a brick wall by changing the gravitational field around it. Researchers at the University of Queensland (UQ) encoded binary data in the movement of a 1950s lift and decoded it with a gravimeter in a nearby restroom. The experiment shows that a signal based on gravity can cross an ordinary barrier, though its data rate remains far from practical communication speeds.

Encoding data in a moving mass

The team sent the lift repeatedly between two floors. Its counterweight shifted between positions assigned to binary zero and one; a gravimeter in an adjacent restroom measured the resulting tiny variations in the local gravitational field. The detector converted that sequence into the word “Gravity,” seven letters that took about an hour to transmit.

A gravimeter measures small changes in gravitational acceleration. Geophysicists use these instruments to study features such as underground oil reserves, shifting magma beneath volcanoes and changes in polar ice. Here, the same measurement principle was applied to a moving counterweight inside a university building. The challenge was detecting the counterweight’s small, distant contribution amid the much larger gravitational pull of Earth.

The setup depends on movement rather than a radio transmitter. Each change in the counterweight’s position produces a correspondingly small change in the gravitational field at the detector. By assigning positions to binary symbols and recording the variations, the researchers could convey a sequence of bits through the wall.

A signal ordinary materials cannot screen

Radio and Wi-Fi signals can be weakened or blocked by structures, depending on their materials and geometry. Gravity behaves differently: ordinary matter between a source and a detector does not screen the gravitational field. Dr. Charles Woffinden of UQ’s School of Mathematics and Physics said the experiment demonstrates a communication method that ordinary physical barriers cannot block, while stressing that the system is far from practical.

That property could matter in places where conventional wireless signals struggle to reach, including underground or underwater environments. The experiment does not establish a working communication system for those settings; it demonstrates the underlying possibility using a slow lift and a nearby sensor. Any useful application would depend on transmitting data faster and detecting weaker changes over greater distances.

The project grew out of work on a contactless weighbridge. Dr. Andrew Groszek and colleagues were investigating whether a system could estimate the mass of heavy trucks from their gravitational pull. As the team developed the ability to detect moving mass remotely, they recognized that controlled motion could also encode information.

Speed and range remain the main hurdles

The elevator transmitted at one bit per minute, making even a short message a lengthy process. Scaling the approach would require moving larger masses faster and using more sensitive detectors, Professor Andrew White said. Those demands point to a basic engineering trade-off: stronger or faster changes in mass could make the signal easier to measure, while improved sensors might detect smaller changes at a distance.

White compared the work’s early stage with the long development from the first telegraph systems to mobile phones. The comparison suggests a possible path for the field, but it doesn’t resolve the physical and engineering constraints that currently limit the method. The result is a demonstration of signal transmission, not evidence that gravity could replace existing wireless networks.

The researchers published their findings in Science Advances and are examining whether quantum technology could improve sensing. Modeling by Professor Matthew Davis suggests that next-generation quantum gravity sensors might support communication over 500 meters at around 15 bits per minute. Those figures are projections from modeling, not results demonstrated by the elevator experiment.

Even at that modeled rate, transmission would remain slow by present communication standards. The more immediate significance is that a detector can recover encoded information from gravitational changes despite a solid wall between the moving mass and the sensor. Further work will need to show whether greater range and data rates can be achieved under real operating conditions.

Matthew Davis, Charles Woffiden and Andrew White inside the elevator they used to send a message. Credit: The University of Queensland
Source: Mrigakshi Dixit · interestingengineering.com

From the same set